Error Message:

MSG: plate thickness too large

Applies to:

• All

Service Information:

The plate thickness sent as part of a load bay command is too large. The maximum plate thickness is currently set at 1 mm, so this message indicates a gross error such as thickness in microns entered as thousands of an inch, etc.

Operator Action:

Check the plate thickness entered in the "Plate Types" dialog box (found in the "Configuration" dialog box). Check that the units (i.e. mm, thousands of an inch) of the measurement from the plate box match the units in the dialog box.

Cause:

• Plate thickness entered incorrectly, likely with the wrong units

See Also: