Error Message:

DRUM: Timeout on hold

Applies to:

• All

Service Information:

When drum is put into hold mode, it must be at it's position (+/- 100 ticks) within 2 seconds.

Operator Action:

Resume and report to Creo Response center.

Cause:

• Possible PID gain settings pgp igp dgp causing hunting in drum hold mode, check also pgs igs dgs (soft hold mode).
• If this happens when the LEC is down, then LEC position set in nvs may be wrong.
• Loose belt or motor pulley.
• Faulty drum amp or motor hall sensors or motor cable.

See Also: