Error Message:

DRUM: Drum Position error during Velocity mode, (extra index possible cause, check monitor values)

Applies to:

• All

Service Information:

While the drum was spinning, or accelerating/decelerating to velocity, the position error was much greater than allowable. The threshold error is 2000 ticks plus an extra factor based on the acceleration.

This error is most likely caused by a premature index that reset the counter.

Operator Action:

Resume and report to Creo Response center.

Cause:

• Premature index - check the encoder.
• Faulty drum amp.

See Also:

• Error: E_DRUM_VELOCITY_POS