Error Message:

CARRIAGE: Specified Speed exceeds maximum of %lu

Applies to:

• All

Service Information:

A speed greater than "carriage mspeed" has been requested. If this happens during normal operation, it is probably a firmware bug or an incorrect NVS parameter. The maximum carriage speed is displayed in the error message.

Operator Action:

Click on CANCEL IMAGE. If the machine does not recover, turn the power to the output machine off and on again. Please contact Creo Service to report this error.

Cause:

• Speed greater than maximum requested in a "carriage move" command.

See Also:

• NVS: carriage ispeed
• NVS: carriage espeed
• NVS: carriage kspeed