Service Information:
|
The Xilinx LCA's on the DPE were not loaded on startup. They are normally loaded using a file stored in
the code bank. To determine if this file is corrupted or missing, use the "fw dir" command. Look for the
entries labelled "DPE LCA". If there, look under the "Chksum" column for either "PASS" or "FAIL". If it
says FAIL, or if no DPE entry is there, the code bank must be programmed again. If the DPE entry
PASS'es, the incorrect firmware file may have been loaded, or the DPE LCA's may be faulty.
|