Error Message:

CABLE: LR plate sensor not connected (J3)

Applies to:

• Trendsetter_400/800_Auto
• Trendsetter_400/800
• Trendsetter_400/800_Proofing

Service Information:

The firmware cannot detect the cable between the TEE board and the sensor on the load ramp used to measure the plate size.

Operator Action:

Cause:

• The cable really is disconnected, or there is a intermittant connection.
• The wiring could be faulty, check J3 of the TEE board (LOAD RAMP SENS).

See Also: