Error Message:

SAT: Engine Leadscrew temperature out of range

Applies to:

• All

Service Information:

The measured leadscrew temperature is outside the range of reasonable values. This is likely due to a disconnected or faulty sensor. The leadscrew temperature sensor is mounted to the leadscrew nut and is disconnected when a head is replaced. If the cable and sensor seem fine, the LUE may be faulty.

Note that faulty temperature readings will result in incorrect plate geometry!

This error message can be temporarily disabled by with "set sat lst 0".

Operator Action:

Record error message and call Creo Service.

Cause:

• Faulty leadscrew temperature sensor or cable.
• Faulty LUE

See Also: