Error Message:

SAT: Software error: invalid lamp state %d in sat_set_lamp_state()

Applies to:

• Trendsetter_400/800
• Trendsetter_VLF

Service Information:

If this error is reported there is a firmware bug. Contact the responsible firmware programmer. The firmware has detected invalid state information for driving the lamps on the operator panel. Valid lamp states are READY, LOAD, IMAGING or ERROR. This error is informational only and no intervention should be necessary as the lamps will be updated on the next load, image or error. If not cycle the power on the machine.

If this error is reported there is a firmware bug. Contact the responsible firmware programmer.

Operator Action:

Record error message and call Creo Service.

Cause:

• Possible firmware bug.

See Also: