Error Message:

ALE: Trailing edge clamp actuator bar cylinder error, both sensors activated

Applies to:

• Platesetter_3244
• Trendsetter_400/800

Service Information:

Reports this error if both extended and retracted tec sensors indicate true after a tec backbone is lowered and a time of te_delay has expired. Only reported if te sensors enabled.

Operator Action:

Check that TEC magnets are lined up, this error will occur if the tec backbone is unable to go all the way down when it tries to retrieve the tec magnetic clamps.

Otherwise call Creo service

Cause:

• sensor or wire failure or TEC Lock failing to unlock or magnets or other obstruction preventing the TEC backbone from going all the way down.

See Also:

• NVS: al nte
• NVS: aldly te cal