Error Message:

ALE: trailing edge clamps failed to lock

Applies to:

• All

Service Information:

Check the clamp lock sensor see is it is operational. Use "tec" command from the diagnostics to display the sensor status. If the sensor is faulty, use "set al tls 0" to bypass the sensor and get the customer going. Arrange for field service. If the sensor is OK, test the TEC lock/unlock mechanism by using "tec lock" or "tec unlock" and see if any motion occurs.

Operator Action:

Click RESUME to see if the error goes away. If not, call Creo for service.

Cause:

• Faulty clamp unlock sensor
• Faulty TEC lock/unlock mechanism.

See Also:

• NVS: al tls
• Command: tec