Error Message:

ALE: Has plate been removed from Drum ? 'Resume'= Yes -*- 'Clear' = No

Applies to:

• Platesetter_3244

Operator Action:

1. Thermal only. This will be reported if an attempt was made to load a plate while there was still a plate on the drum.

If there is infact no plate on the drum then select "resume" otherwise select "clear"

To remove a plate from the drum consult operator manual or operator training notes.

Service Information:

resume sets plate_loc D status to 0 (empty). Clear abandons the load attempt.

Cause:

• Thermal only. This will be reported if an attempt was made to load a plate while there was still a plate on the drum.

See Also:

• Command: getclamp
• NVS: plate_loc General_syntax_PS3244