Error Message:

ALE: STEP : axis 2 communication error

Applies to:

• Trendsetter_400/800_Auto

Operator Action:

Remove the plate from the unload table and select the PLATE REMOVED button on the workstation dialog box. If the problem persists, then Creo Service should be called.

Service Information:

This error occurs when there is a communications problem between the firmware and the stepper controller on the TEE-board.

Cause:

• If the procedure described in Operator Action does not correct the problem, then the stepper controller must be re-initialized. Do this either by typing TABLE INIT or (if that does not work) resetting the recorder.

See Also: