Error Message:

ALE: STEP : axis 2 is busy

Applies to:

• Trendsetter_400/800_Auto

Operator Action:

First try selecting the RESUME button on the workstation dialog box a few times. If this does not make the problem go away, then Creo Service should be called.

Service Information:

This error occurs when the stepper motor is currently executing a command and another command is issued to the stepper motor.

Cause:

• If the procedure described in Operator Action does not correct the problem, then the stepper controller must be re-initialized. Do this either by typing TABLE INIT or (if that does not work) resetting the recorder.

See Also: