Error Message:

ALE: STEP : axis 2 not initialized

Applies to:

• Trendsetter_400/800_Auto

Operator Action:

This error should not occur during normal machine operation. If it does, first try selecting the RESUME button on the workstation dialog box a few times. If this does not make the problem go away, then select RESET PLATESETTER RECORDER from the workstation SYSTEM pull-down menu. If the problem persists, then Creo Service should be called.

Service Information:

This error occurs if a TABLE MOVE or TABLE JOG command is issued from the diagnostic monitor before an TABLE INIT or ALE INIT command. This error should not occur during normal machine operation.

Cause:

• Type TABLE INIT or ALE INIT at the diagnostic monitor prompt.

See Also: