Error Message:

ALE: STEP : axis 1 communication error

Applies to:

• Trendsetter_400/800_Proofing

Operator Action:

Select RESUME from the workstation dialog box. If that doesn't correct the problem, then select RESET TRENDSETTER from the workstation TRENDSETTER pull-down menu. If the problem persists, call Creo service.

Service Information:

Try cycling power on the machine. Check the SPI and TEE boards and replace them if necessary. If problem recurs, call proofer TTE.

Cause:

• An error occurred while communicating with the VR stepper controller. A hardware fault likely caused this.

See Also: