Error Message:

ALE: Proof type #<n> is invalid or not set up correctly

Applies to:

• Trendsetter_400/800_Proofing

Operator Action:

This error should not be seen under normal machine operation. Call Creo service.

Service Information:

The drum state parameters have been corrupted. Do a "set state plate_loc d proof <n>" where <n> is the proof type which is being attempted (between 1 and 8). If this problem persists, contact the Proofer TTE.

Cause:

• Somehow the drum state parameters have been corrupted. This is likely due to someone entering invalid commands from the diagnostic monitor.

See Also:

• NVS: plate_loc ptype