Error Message:

ALE: %s %d timed out while homing

Applies to:

• Trendsetter_VLF
• Platesetter_VLF

Service Information:

Check for a low value of the NVS parameter "home_timeout" by typing "set altim home" in the diagnostic monitor. This value is the maximum time allowed by the firmware for homing a stepper axis. Verify the mechanics for anything that could prevent the axis from moving at a normal pace.

Operator Action:

This is not an operator serviceable error. Press resume or reset the machine to continue production. Call CreoScitex response center.

Cause:

• An axis in moving home but did not reach its destination fast enough.

See Also: