Error Message:

ALE: picker Z-axis not in position for plate grab

Applies to:

• Trendsetter_VLF
• Platesetter_VLF

Service Information:

Picker Z-axis was sent to the away position but the home/away board does not detect the away tab.

Operator Action:

Cause:

• The nvs parameter "step 3 away_limit" may be too small so that the picker Z-axis does not reach its destination.
• The picker Z-axis home/away board may not be working properly.
• Something may be preventing this axis from reaching its away position.

See Also:

• Other: Troubleshooting information