Error Message:

ALE: plate length wrong. Remove plate from load table and configure bay

Applies to:

• Platesetter_VLF

Service Information:

Check for messages in diagnostics regarding the plate. These messages begin with "Warning:" and should indicate the problem that is causing this error. The measured plate size and its error are also reported.

Operator Action:

Manually remove plate and confirm through workstation. Ensure that the plate dimensions match those configured for the workstation.

Cause:

• During loading of the plate onto the load table, the mainscan size of the plate is measured. If the plate is not within nvs.cfg.load.plate_length_tol, this error is generated.

See Also: