Error Message:

ALE: timeout moving balance weight actuator

Applies to:

• Trendsetter_VLF

Service Information:

Check for a low value of the nvs parameter 'altim bct' (balance cylinder timeout). Verify that the balance cylinder extended/retracted sensors are working properly, and check the wiring/plumbing.

Operator Action:

This is not an operator servicable error. Press resume. Call CreoScitex service. Reset the machine to continue production.

Cause:

• A command to move the balance cylinders to the extended or retracted position timed out, either because the timeout was too small, a failure moving the actuator, or a failed sensor.

See Also: