Error Message:

IMAGE: Total subscan shift less than zero

Applies to:

• All

Service Information:

The net subscan shift is calculated from the following parameters:

1. "set gc sss" - nominal shift, the same for all recorders of the same model
2. "set gc sssa" - adjustment made during integration
3. "set mode <mode> sssa" - the workstation can overwrite this shift with a new one for each image

If these parameters do not add to be greater than zero, the workstation must have sent a negative shift which caused the total shift to be less than zero.

The values of the "gc" parameters should be compared to the factory settings. If these settings are not the problem, the source of the negative shift from the workstation should be found and adjusted.

Operator Action:

Record error message and contact Creo Service

Cause:

• "set gc sss", "set gc sssa", and/or "set mode <mode> sssa" shift parameters are incorrect
• Workstation is specifying a large negative shift along the drum.

See Also:

• NVS: gc sss
• NVS: gc sssa
• NVS: mode sssa