Error Message:

IMAGE: DPE orthog slope larger than max, check plate rotation

Applies to:

• All

Service Information:

The rotation needed to correct for the registration pin placements is too large. Check that the "set gc prot", "set gc sprot" and the "set gc ortho" parameters are at their factory settings (refer to the NVS configuration record). If they are, and this error is still reported, a firmware bug may be responsible.

Operator Action:

Record error message and call Creo Service.

Cause:

• NVS "set gc prot", "set gc sprot" or "set gc ortho" parameters changed from factory settings.
• Firmware bug.

See Also:

• NVS: gc prot
• NVS: gc sprot
• NVS: gc ortho
• Other: Troubleshooting information