Error Message:

HEAD: did not signal end of initialization

Applies to:

• All

Service Information:

The head is not initializing properly. The head may be faulty, or its parameters may not be setup properly. The exposure head to backplane (EH-BP) cable should be checked. The exposure head's digital board should also be checked (parameters stored in EEPROM must be restored if the board is swapped). Check that the board has +5V.

Operator Action:

Reboot the Platesetter. Record error message and contact Creo Service

Cause:

• Head parameters not setup correctly
• Faulty EH-BP (exposure head to backplane) cable
• Exposure head digital board faulty or not mounted correctly
• Faulty head

See Also: