Error Message:

SCSI: SCSI bus reset while imaging

Applies to:

• All

Service Information:

The recorder detected that the SCSI bus was reset during imaging. This error can normally be safely ignored as no side effects of the bus resets have been observed.

If the image was aborted or suspended due to this error, the NVS parameter "set sys asr" should be set and saved to 0.

Operator Action:

If this message appears in a Suspend Dialog Box, click on RESUME or CANCEL. The platesetter will recover and normal operation may continue, although the current plate will be rejected. Contact Creo Service to disable this error message.

If this error is displayed only in the message window, it can be safely ignored.

Cause:

• Some workstation SCSI drivers reset the SCSI bus spontaneously with no apparent side effects.

See Also: