Error Message:

ALE2: Measured height = %imm (%i.%i\"), Entered = %imm (%i.%i\") - RESUME to use measured

Applies to:

• ThermoFlex

Service Information:

If size is always coming out short - check that plates are cut squarely and table plate sensor is being covered for the entire length of the plate. Re-calibrating the stl parameter may be required if the plates are OK.

Operator Action:

If measured plate size is still acceptable select resume otherwise cancel.

Cause:

• The measured plate size does not agree with the submitted plate size within tolerance.

See Also: