Error Message:

ALE2: NOTE: Slipsheet sensors did not detect slipsheet beteen plates. Check media x sst

Applies to:

• Trendsetter_VLF_Auto

Service Information:

Slipsheet sensor detected a plate on the top of the lower plate During picking. This is not an error if the media sst is set correctly, it is however unusual and means that the firmware will attempt to pick a slipsheet from the bottom of the plate lifted by the pcups. If however the media sst is not correct, that will cause the ss sensor to not recognize a slipsheet when there is one, which will then also give this warning.

Operator Action:

Cause:

See Also: