Error Message:

SCON: Stepper Motor %u driver under voltage fault detected

Applies to:

• Trendsetter_VLF_Auto

Service Information:

Check voltage in on 48V on J1-1 & J1-2, +12V in on J1-5, and -12V in on J1-4. The status is on TP6 (high=fault low=ok). You can read the 24 and 48 V as read by each genine by typing 'ale'.

Operator Action:

Cause:

• Remote stepper driver under voltage fault was detected. The under voltage fault signal is the combination of +12 low, or -12 low or the 48 V low, as read by on the Carriage board (10-3761B) and passed as a digital status signal to the Genine. Variable: <%u> - motor number

See Also: