Error Message:

SW: AL Sched: unload sync error

Applies to:

• All

Service Information:

The recorder has detected an impossible autoloader situation. This is likely due to autoloader commands issued via the diagnostic monitor while workstation images are active. The recorder has been automatically reset to re-synchronize. If this error is reported and no autoloader diagnostic monitor commands have been issued since the last few plates, report this error to the responsible firmware programmer.

Operator Action:

The recorder has been reset and should recover automatically. In any case, report the error to Creo Service.

Cause:

• Autoloader diagnostic monitor commands issued while images active.

See Also: