Long Name:

Applies to:

Description:

This is the location that the picker moves to initially when going to pick a plate. This should place the 'Bay' sensor on the picker H/A board over the bay tab, about 5mm from the back of the tab.

To change the value enter the command as "SET BAY # LOC ##" where # is the bay number and ## is the new location position. Approximate bay positions for 3244 are: Bay 1 = 1030. Bay 2 = 1560. Bay 3 = 2100. Bay 4 = 2630.

Type:

Default:

• 0

Range:

• 0.0 to 10000.0 [mm]

Notes:

If the picker ends up beyond (aft of) the tab, the firmware will move the picker forward by bay_tab_search_y (alpos btsy) to over the tab then move back till just clear the bay tab (plus an inch of latency)

Partition:

See Also: