Description:
|
Edge search distance on second pass (twice this distance on the third pass,
etc). The search is centred on the expected plate edge position, i.e. started
half the search distance from the expected plate edge. If this is the first
plate from a bay after it has been loaded, this search distance is used on the
first pass. Normally not changed from default. If the autoloader is having
problems placing plates from the same bay in the same spot each time, this
parameter could be increased slighlty to optimize edge search time. Otherwise,
if this parameter is too small, the "edge not found" error may be reported or
the first pass after bay loading may fail too often. If this parameter is too
large, this pass may take longer than necessary. Both cases will result in
increased average search times for the first plate out of a bay.
|