NVS Parameter: hdm wpowers

Long Name:

 wr_laser_power_std

Applies to:
  • Thermal

    • Description:

    Laser standby mode does not turn off the write laser at the end of a plot. Instead, write laser output power is reduced to the value determined by this NVS parameter. If after fifteen minutes another plot is not launched, then the write laser is turned off.

    See the description for wpower for further details.

    Type:

    		 real

    Default:
    • 0.000

    Range:
    • 0.000 to 30.000 [watts]

    Notes:

    Applies to Thermal Head firmware version 1.30 and above

    Partition:

    		 cal

    See Also:
  • NVS: hdm wpower
  • NVS: hdm wpowern
  • NVS: head wpwrcal

    • Go to CTP Firmware NVS Parameter Index Page

    Go to CTP Firmware NVS Parameter Search Page

    Go to CTP Firmware Main Page

    Creo CTP F/W NVS Parameter Documentation / ctp_firmware@creo.com / Updated: Tue May 14 20:03:36 2002 PST