| Variables | diode | Diode to set (0 to 63, or all). |
| power | Power to set (mW). | |
| Description | Set the power of one or all diodes. The current is looked up on the power curve, and the diode is set to that current. | |
| Notes | If you set all diodes on an older head (ex. ld all 800 mw) and a diode is marked as dead, that diode will still receive current because the difference between the lowest diode and highest diode cannot exceed 1 amp. The diode will be set to the current of the lowest living diode. | |
| Related Documents |
ERRORCODE: [00903] Power curve not initialized | |
|
ERRORCODE: [00908] Requested power is too low | ||
|
ERRORCODE: [00904] Power curve is invalid | ||
|
ERRORCODE: [00906] Nullified diode - no power curve | ||
|
ERRORCODE: [00606] Current range too great | ||
|
ERRORCODE: [00607] Current limit exceeded | ||