|
|
|
|
| media
| Media index, numbered from 0.
|
|
| power_points
| Up to 7 power_points, used in velocity curve. (mw)
|
The velocity power curve is used with the sleeve engine. When using different sleeve diameters, the surface velocity varies, and the diode power must vary as well to keep exposure constant. The velocity power curves store information on the power required at various surface velocities for each media.
|
|
| If no power points are specified, the power points for the specified media will be displayed at the monitor.
|
|
| When power points are specified, this command sets the power points for the velocity power curve for the specified media. There must be one power point for each velocity point on the curve.
|
These values are set in production, and should not be changed unless you fully understand the consequences. The power points are specified in units of mw.
|
COMMAND: vpc velocity <media> [<velocity_points>]
|
|
|
ERRORCODE: [05300] Invalid function parameter
|
|
|
ERRORCODE: [05307] The specified media index is out of range
|
|
|
PARAMETER: vpc <media> power_points
|