|
|
|
|
| media
| Media index, numbered from 0.
|
|
| velocity_points
| Up to 7 velocity_points, used in velocity curve. (m/s)
|
The velocity power curve is used with the sleeve engine. When using different sleeve diameters, the surface velocity varies, and the diode power must vary as well to keep exposure constant. The velocity power curves store information on the power required at various surface velocities for each media.
|
|
| If no velocity points are specified, the power points for the specified media will be displayed at the monitor.
|
|
| When velocity points are specified, this command sets the velocity points for the velocity power curve for the specified media. When these are set or changed, the corresponding power points must be changed as well.
|
These values are set in production, and should not be changed unless you fully understand the consequences. The velocity points must increase in value, and are specified in units of m/s. The minimum velocity is 1.5 m/s, and the maximum velocity is 14 m/s.
|
COMMAND: vpc power <media> [<power_points>]
|
|
|
ERRORCODE: [05300] Invalid function parameter
|
|
|
ERRORCODE: [05307] The specified media index is out of range
|
|
|
PARAMETER: vpc <media> velocity_points
|