|
|
|
|
| point
| Selects the sample point from 0 to 8.
|
Display / configure the plot configuration. The possible sample points are as follows:
|
|
|
- Load Estimate
- Autofocus
- WriteLaser
- Beam Pointing
- Beam-Balance
- Int. Balance
- Plot State
- LVD State
|
|
| The monitor command log plot will display the plot configuration and the monitor command log plot <point> (enable|disable) will configure the sample point.
|
|
| Any combination of sample points may be enabled.
|
Thermal 1.0 / 1.7x equivalents:
|
|
|
- The monitor command log plot [<point> (enable|disable)] does not have an equivalent.
|
|
| Thermal 2 equivalents:
|
|
|
- The monitor command log plot [<point> (enable|disable)] does not have an equivalent.
|
COMMAND: log mode (sample|plot) (enable|disable)
|
|
|
COMMAND: log sample [<point> (enable|disable)]
|