Description:

View the status of, or perform general commands on the proofing loader system. The following command options are possible:

• proof - Displays the status of all the proofing loader mechanisms and sensors.
• proof init - Initializes the proofing loader mechanisms.
• proof upgrade - Use this command after you have upgraded a trendsetter in the field with the proofing option or when you are upgrading a trendsetter to include the proofing option. (Obsolete after version 1.1). See the separate command documentation for "proof startup" and "proof integrate"
• proof startup - See the separate command documentation for "proof startup".
• proof integrate - See the separate command documentation for "proof integrate".
• proof usage - See the separate command documentation for "proof usage".
• proof reseat - See the separate command documentation for "proof reseat".
• proof mode - See the separate command documentation for "proof mode".
• proof clean - See the separate command documentation for "proof clean".
• proof c_verify - Use this command to test the carrier verification routine and to calibrate the carrier hole position NVS parameter. See the separate command documentation for "proof c_verify".
• proof media seal - Perform the active media seal routine to seal the donor and receiver to the drum. See the separate command documentation for "proof media seal".
• proof cal - In the future this command will execute a calibration routine.

Applies To:

• Trendsetter_400/800_Proofing

Syntax:

Notes:

See Also:

• Command: proof mode
• Command: proof c_verify
• Command: proof media seal
• Command: proof cal
• Command: proof startup
• Command: proof integrate
• Command: proof clean
• Command: proof reseat