Error Message:

DRUM: Servo amp fault

Applies to:

• All

Service Information:

Drum init will not clear this fault latch on older firmware (< drum module 1.15)

Operator Action:

Reset the machine, if the fault does not go away, power off the machine and start up again. If the fault is reported again after the machine is initialised, type <drum init> at the monitor. If it still reports an error you should call Creo service. It may help to leave the machine off for 20 minutes if the fault was caused by high temperature.

Cause:

• Digital output from Automotion drum amp, latched in drum amp hardware. see Technical library/<product>/troubleshooting/main drive amp.

See Also:

• Other: Troubleshooting information