Error Message:

ALE: trailing edge clamp status conflict, setting te state flag to <0|1>. ( "1" indicates "on drum", "0" indicates "on tec backbone" )

Applies to:

• Platesetter_3244
• Trendsetter_400/800
• Trendsetter_400/800_Auto

Service Information:

The recorder logs this error if it finds the TEC magnets on the backbone but the flag indicates that they should be on the drum; or if it finds the TEC magnets are not on the backbone but the flag indicates that they should be there.

Operator Action:

Select Resume is that option is available. If the problem persists, power down the machine, wait a few seconds, then turn it back on.

Cause:

• Faulty TEC magnet sensor.
• Machine in strange state. Reset and continue.

See Also:

• Command: getclamp
• NVS: al te