Error Message:

ALE: trailing edge clamps already on actuator, possible sensor or software error.

Applies to:

• All

Service Information:

If no clamp is on the TEC actuator, check for faulty magnet sensor by using "tec" command. If it is faulty, use "set al ms 0" to bypass the sensor and get the customer going. Arrange for field service.

Operator Action:

Select RESUME and see if it works. If not, call Creo service.

Cause:

• Faulty TEC magnet sensor
• Firmware bug

See Also:

• NVS: al ms
• Command: tec