Error Message:

ALE: timeout moving bay <bay#> shutter cylinder

Applies to:

• Platesetter_3244

Service Information:

Check for mechanical interferance, Check alignment of shutter cylinder Hall effect sensors, and cabling.

Operator Action:

Resume, Open side panels and check that shutter is not obstructed. Call Creo service if problem persists.

Cause:

• Bay shutter closed sensor was not detected within "shutter_delay" while closing, or bay shutter open sensor was not detected within "shutter_delay" while opening. If opening when this error occurs then the firmware will close it again, (set verbose 1 for message)

See Also:

• NVS: al nss
• NVS: aldly shut
• Other: Troubleshooting information