Error Message:

ALE: End of bay <bay#> detection tab not found, picker may be stuck.

Applies to:

• Platesetter_3244

Service Information:

check bay sensor using "picker" or "sat stat pkr". check that bay tab is not damaged. check bay locations. (cal bay f/w 2.25) Replace H/A board / cables. Check for PY stalling / driver problems.

Operator Action:

Resume. If problem persists, reset machine, remove plates as required during start up.

Cause:

• Y axis stopped because distance (btsy) was moved but never found tab.

See Also:

• NVS: bay loc
• NVS: alpos btsy
• ##Comand: cal
• Other: Troubleshooting information