Error Message:

ALE: remove plate from conveyor or check sensor

Applies to:

• Platesetter_3244

Service Information:

Check conveyer plate sensor and cables. For S conveyer check fence. Check rollers operate.

Operator Action:

Lift lid of plate rotator and remove plate or push into processor, then Resume.

Cause:

• This error is reported if there is still a plate sensed in the conveyer when shutting down the rollers after timing out: processor_infeed_delay (if processor interface enabled) + plate_process (error only reported if plate conveyer is enabled.)

See Also:

• NVS: al npc
• NVS: altim plate
• NVS: aldly pid
• Command: conveyer
• Command: processor