Error Message:

ALE: Please unload plate

Applies to:

• Trendsetter_400/800
• Trendsetter_400/800_Proofing

Operator Action:

Remove the plate on the load ramp.

Service Information:

This message is not an error. It is used to prompt the user to load a plate. If this window does not go away after the plate is removed, the load ramp sensor may not work properly. Check for any debrid blocking the sensor. If the sensor is clean, use "set al lps 0" in diagnostic monitor to bypass the sensor to get the customer going and arrange for field service.

Cause:

• The load plate sensor is dirty, damaged or misaligned.

See Also:

• NVS: al lps