Error Message:

ALE: Manual bypass loading is not supported on this machine.

Applies to:

• Trendsetter_400/800_Auto

Operator Action:

This error indicates that your machine is an E-type machine, and manual bypass loading is not supported. If this error occurs on something other than an E-type machine, call Creo Service.

Service Information:

This error is reported when the workstation tries to launch a manual-bypass job on an E-type machine. Manual bypass loading and unloading is not supported on these low-cost E-type machines.

Cause:

• A manual load or manual unload was requested from the workstation, or through the diagnostic "mload" or "munload" commands.

See Also:

• Command: mload
• Command: munload
• Command: config
• NVS: config type