Error Message:

IMAGE: surface depth of %ld microns above maximum limit of 1000 microns

Applies to:

• Thermal

Service Information:

The requested surface depth before a plot was above the upper limit of 1000 microns (um). The requested surface depth is specified in the error message.

If a sd test series plot was started or underway, the requested surface depth for the next series step was higher than the limit.

Operator Action:

Check that the correct media type was selected for the current image, then try the image again. If the problem persists, call Creo Customer Support for help.

Cause:

• The NVS media sd setting may be too high.
• The workstation specified a media type that was not normally used, which has a NVS media sd setting that is too high.
• A surface depth series plot was started or underway, and the requested surface depth for the for the next series step was higher than 1000 um.

See Also:

• Command: plot sd
• NVS: media sd