Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
Home | Contact Us | Submit Troubleshooting Info | Search | Help
Output | Software Solutions | Proofing | Color, Screening and Calibration | Scanning | Digital Photography | Consumables | POS
Main Firmware | Recovery code | Boot code
The main operating firmware that controls the satellite I/O board during normal operation. Resides in a field eraseable flash sector.
| Version | Status | Part # / ECO | Date | Notes |
| 1.17 | Unreleased | Dec 2002 | ||
| 1.16 | Released | 19-3417A /E857 | Nov 2002 | Caution: Ensure you have at least BBR ver 1.03 or later already installed before attempting to upgrade the satellite board firmware over the CAN Bus. |
| 1.15 | Released | Release Notes |
This firmware is downloaded over the diagnostic serial port when the BBR is running. Use the Bload.exe utility v1.09 or newer. Normally this will never be required, unless the BBR could not find valid Boot code.
| Version | Status | Part # / ECO | Date | Notes |
| 1.00 | Released | 19-3415A /E857 | Nov 2002 | Download over serial port. |
Runs from a field eraseable flash sector. Allows downloading of the main firmware across the CAN bus.
| Version | Status | Part # / ECO | Date | Notes |
| 1.00 | Released | 19-3416A /E857 | Nov 2002 | This boot code can only be programmed into the Lionel board by using the P&E "Cable12" BDM programming device attached to the PC parallel print port. |