Version Effective

Change

9.069

Unload improvement - when using 7/4 mil film or plates, the imagesetter pulls the film or plate 4 mm backward before the cutter returns to home position. This prevents the cutter and the film or plate from colliding.

9.068

Unload improvement - while using a 7 mil film/plate, the imagesetter pulls the film/plate 3 mm backwards before the cutter returns to home position. This prevents the cutter and the film/plate from colliding.

9.067

Supports new Tung Shung film processor.

Enables faster spinner speeds for imagesetters with old cards (CRI, Fast HOMC, Strobe5, Fast Strobe5). This feature is effective for the TelePress and Dow Johns.

Fixed imagesetter identification Dolev 4pressV² and 4NewsV² for correct identification on the front ends.

Fixed the interrupt save problem (changed the unsafe structure to a safe one).

Changed the maximum film feed to the Inline processor while using bar punch (the default is 630mm) from 500-1000 to 300-1000. This change allows us to save film.

Fixed the bug that reduces spinner speed from 24000 rpm to 17000 rpm because of data rate of less then 33MHz.

9.065

Fixed imagesetter identification Dolev 4pressV² and 4NewsV² for correct identification on the front ends.

Fixed the interrupt problem (changed the unsafe structure to a safe one).

Fixed black spot problem. The machine now always performs at the startup in the following sequence: moves the carriage to the middle of the drum (for supporting the film) and then performs HP before laser calibration.

Changed the maximum film feed to the Inline processor while using bar punch (the default is 630mm) from 500-1000 to 300-1000. This change allows us to save film.