Dolev Setup diskette for Flash, DOC & SDOC release notes

Since the DOC chip status is "last-time-buy", you can follow this procedure for the setup version.

1. Download setup flash file #1 to a floppy diskette.
2. Download setup flash file #2 to a different floppy diskette.
   Note: Make sure that the two diskettes are write-protected - enabled.
   
3. Insert diskette # 1 in the floppy drive and turn on the plotter.
4. Turn off the plotter.
5. Insert diskette # 2 in the floppy drive and turn on the plotter.
6. Insert the relevant Dolev microversion and reboot the plotter.
7. Insert the relevant Diagnostics version and reboot the plotter.
8. Check that the correct version is installed.

Ordering information