Dolev 4press - Procedures
Maintenance Procedure

BASIC MAINTENACE TOOL SET

The following is the basic set of tools required for performing procedures appearing in this section:

proc1.gif (13194 bytes)
Imagesetter Right Side View

1. Accum. Cassette Motor	8. Static Optics Unit
2. Accum. Cass. Axis Location Detector	9. Carriage End Position
3. Upper Drawer Detector	10. Take Motor
4. Load Motor	11. Cutter End Position
5. Light Detector	12. Cutter Motor
6. Dynamic Optics	13. Load Cassette Detector
7. Panel Connection	14. Lower Door Solenoid

proc2.gif (15785 bytes)
Imagesetter Left Side View

1. E-Box Unit	8. Film Guide on Carriage
2. Film-In Detector	9. Carriage Home Position
3. Dynamic Cable Connection	10. Stepper Motor
4. Film Path Selector	11. Upper Door Solenoid
5. Cutter End Position	12. Film Guide Upper Door Release
6. Drum Exit Encoder	13. Film Guide Lower Door
7. Dynamic Cable	14. Film to Accum. Cassette Encoder

proc3.gif (14303 bytes)
Imagesetter Rear Electronics Panel

J1. Machine Control	J10. Stepper Control
J2. Spinner Control	J11. Processor (Optional)
J3. Floppy Disk	J12. Vacuum Power (Optional)
J4. E-Box Fan	J13. Mains to D-Box
J5. Fan (Optional)	J14. +12, Pwr 12, Interlock, Panel On/Off
J6. Detectors and LDT Control	J15. +15, -15, -5.2
J7. Floppy Power	J16. VMB Supply to Spinner VM Supply to Stepper
J8. Laser Driver	J17. +5, +12, -12
J9. ± 12 VDC to D-Box

1. VGA	6. COM4 RS-232 Differential
2. COM1 RS-232	7. E-Box PC Board Locker
3. COM1 RS-232	8. Mains to Power Supplies in P-Box
4. Keyboard	9. Mains (Optional)
5. COM3 RS-232 Differential