Dolev 800V²

Installation Note

Ady Posner
January 27, 2000

The Dolev 800V² installation procedure is the same procedure as for the Dolev 800V with the following changes:

1. No system diskette is required for start-up. The system is on the flash disk and it will be loaded as the machine turned on.
2. The On/Off switch is located in the rear side of the operating panel and not on the right side of the machine.
3. The reset button is located on the rear side of the operating panel.
4. After the mechanical installation, connect the power cord and turn on the machine.
5. In case that parameters need to be loaded or new system version is needed please note that the floppy disk drive is located on the standard controller side.

Enclosed are two pictures of the operation panel: